Institute of Fundamental Technological Research

Water-soluble regioregular poly{3-[(6-sodium sulfonate)hexyl]thiophene} (PT6S) and poly{3-[(6-trimethylammoniumbromide)hexyl]thiophene} (PT6N) have been synthesized and employed both as photoactive layers for the assembling of “green” bulk-heterojunction organic solar cells and as charge-collection layers in a cell with “classic” architecture. While the photovoltaic performances obtained with the two aforementioned polymers were lower than the reference cell, their latter use allowed to notably increase the inherent J-V properties, leading to a considerable enhancement in the overall photovoltaic output. The power conversion efficiency of the optimized multilayer BHJ solar cell reached 4.78%, revealing a higher efficiency than the reference cell (3.63%).

Water-soluble polymer, Polythiophene derivative, Bulk heterojunction, Organic photovoltaic, Interfacial layer

A novel thiophenic tetramer containing a cinnamate group in the side chain with a functionalization degree of 50% is reported. The tetramer was obtained by means of a simple and straightforward procedure involving the functionalization of a p-methoxyphenoxy substituted thiophenic precursor, which led to a soluble product with a good yield. The oligomer was fully characterized from a structural and chemical point of view and employed for the fabrication of small molecule organic solar cells exploiting the bulk heterojunction (BHJ) architecture. The presence of an UV-light sensitive group in the tetramer allowed the photocrosslinking of tetramer/PCBM blends, giving high values of photocurrent and conversion efficiency for the exposed samples. Moreover, the UV-treated devices showed improved stability, even upon heating for three days at 130 °C, thus confirming that photocrosslinking can strongly reduce phase segregation under severe operational conditions.

electronic materials, polymers, fullerenes, nanostructures, electrical characterization, semiconductors

In this article we demonstrate the use of a blend made of two regioregular polythiophenic derivatives, namely poly(3-methylthio)thiophene and poly(3-hexyl)thiophene, to obtain conductive traces by the simple laser exposure of their thin films to a suitable laser source. The polymeric blend was also tested as a photoactive layer for BHJ solar cells, showing an improved surface morphology and a wider absorption spectrum, thus resulting in an enhanced photovoltaic performance. In the standard condition normally used for the cell preparation, we obtained a 3.16% power conversion efficiency. The device showed good reproducibility and stability over time.

Electrical conductivity, Laser tracing, Bulk heterojunction polymeric solar cells, Regioregular polyalkylthiophenes, Polymer blends

This article describes the preparation of thin films of conjugated polymers which can enhance their specific electrical conductivity by several orders of magnitude by changing their state from insulating to conducting materials. The examined polymers, i.e., a polyacetylenic and a polythiophenic derivative, are functionalized with thioalkylic side chains and are soluble in common organic solvents from which they lead to thick homogeneous films. The films can be deposited on different substrates, either rigid or flexible, and can be easily exposed to laser radiation to make them conductive. The process is irreversible, and the final conductivity is stable over time, even in the presence of high temperatures (up to 180°C), moisture, and air. The high stability of treated samples, easy polymer synthesis and quick and inexpensive suitably tailored laser tracing procedure make these materials very promising for applications in organic electronics and in the development of new electronic circuitry.