Instytut Podstawowych Problemów Techniki

Streszczenie:

Diabetic wound infection often leads to compromised healing with frequent chances of sepsis, amputation and even death. Traditional patient care emphasized on early debridement and fluid resuscitation followed by intravenous antibiotics therapy. However, compromised vasculature often limit the systemic effect of antibiotics. Current study focused formulation of chitosan HCl, κ- carrageenan and PVA based physical cross-linked hydrogel membrane dressings loaded with cefotaxime sodium (CTX), for potential diabetic burn wound healing by adopting solvent casting method. Results of mechanical strength shows tensile strength and % elongation of 12.63 0.25 and 48 respectively. Water vapor transmission rate (WVTR) depicts that despite of formulation KCP3 and KCP6, all hydrogel membranes have WVTR value in range of ideal dressing i.e., 2000–2500 g/m2/day. Whereas, all hydrogel membranes have oxygen permibility values more than 8.2 mg/ml. Bacterial penetration analysis confirms the barrier property of formulated membranes. Drug loaded hydrogel membrane showed control release up to 24 hr which provide protection against bacterial proliferation. Present study aims to constructs diabetic burn rat model which demonstrate that CTX loaded hydrogel membrane shown significantly rapid wound closure higher re-epithelization and numerous granulation tissue formation as compared to positive and negative control group. Conclusively, it is confirmed that formulated hydrogel membranes are beneficial and can be considered as a promising membrane dressing to treat diabetic burn wound.

Słowa kluczowe:

Biomimetic membranes,Biopolymer,PVA,Diabetic wound,Wound healing Ceftriaxone

Afiliacje autorów:

Streszczenie:

Oral drug delivery is natural, most acceptable and desirable route for nearly all drugs, but many drugs like NSAIDs when delivered by this route cause gastrointestinal irritation, gastric bleeding, ulcers, and many undesirable effects which limits their usage by oral delivery. Moreover, it is almost impossible to control the release of a drug in a targeted location in body. We developed thermo-responsive chitosan-co-poly(N-isopropyl-acrylamide) injectable hydrogel as an alternative for the gastro-protective and controlled delivery of loxoprofen sodium as a model drug. A free radical polymerization technique was used to synthesize thermo-responsive hydrogel by cross-linking chitosan HCl with NIPAAM using glutaraldehyde as cross-linker. Confirmation of crosslinked hydrogel structure was done by Fourier transform infrared spectra (FTIR). The thermal stability of hydrogel was confirmed through thermogravimetric analysis (TGA) and differential scanning calorimetry (DSC). The scanning electron microscopy (SEM) was performed to evaluate the structural morphology of cross-linked hydrogel. To evaluate the rheological behavior of hydrogel with increasing temperature, rheological study was performed. Swelling and in vitro drug release studies were carried out under various temperature and pH conditions. The swelling study revealed that maximum swelling was observed at low pH (pH 1.2) and low temperature (25 °C) compared to the high range of pH and temperature and it resulted in quick release of the drug. The high range of pH (7.4) and temperature (37 °C) however caused controlled release of the drug. The in vivo evaluation of the developed hydrogel in rabbits demonstrated the controlled release behavior of fabricated system.

Słowa kluczowe:

Thermosensitive hydrogels, Chitosan, NIPAAM, In vivo study, Biomaterials

Afiliacje autorów: